1.6 GSi wiring woes

[Hypersonik]

Hello there

I'm in the process of building up my 1.0 into a 1.6. I was going to run it on Carbs, but MSA road rally regs won't allow it.

So I need to put the injection system on.

Now I have all the parts but am having a few problems.

The engine turns over but there is absolutely no spark :confused:

I don't have the water temp and oil pressure sensors connected, but I can't see these causing a problem.

What I could really do with is a wiring colour code diagram.

Any help would be appreciated though!

Cheers
Ron

[alan b]

are you getting petrol? if not maybe the ecu aint wired up right. if you are sounds like coil is gone or maybe just wired wrong?

[Adam]

Have you wired the ecu/coil using the black wire that used to go to the 1L coil?

[Ernie]

Thats how mine was wired up into my old 1ltr shell.
http://img.photobucket.com/albums/v617/chunny01/stick3.jpg
When it had the 1'6 fitted and still is now and runs this fine.
http://img.photobucket.com/albums/v617/chunny01/03042007001.jpg

[General Baxter]

Have you wired the ecu/coil using the black wire that used to go to the 1L coil?

im sure theres a 6v wire down there its suppost to be a 12v :confused: :confused:

[Ernie]

Mine works fine.

[gsi 2.5 flann]

hi ron
i had a very simulor problem when i changed the girlfriends nova van from desiel to a 1.6 gsi engine. i never got it to start from the ignition. i got round it by adding a push button start to the starter motor which worked every time. hope this can be of some help. martin