bit random but need help speed sensor wire?

[alan b]

hey guys got my digi dash in last nite! well happy with it! anyway, i put in the red top transducer, and connected the three wires to the plug i cut off my old speedo wire, i took a feed for the dash then off this, and the red/blue wire went off to my sri ecu, no ever dince this my car wont idle properly, if im doing 60 and press the clutch it wont stay at 1000 rpm, it just dies, but if im pulling up slowly it will idle just about, at around 600? has this anything to do with the transducers? cheers!

[Adam]

Fit the digidash transducer onto the top of the sri one(it screws on)
The SRI ecu needs a speed signal, its not getting one atm which is why the engines cutting up(with no speed signal, idle speed control is disabled)

Wire the original transducer to the ecu, and the digidash one to the dash.

[alan b]

so screw the top part off? and use the original tranducer with the redtop top part?

[Rich]

Or just run a wire from the speed sensor at the dash, to the ecu thats all i did.

[Adam]

Either the sri ecu doesn't work with the digidash transducer, or the wires not connected right.
You can screw the transducers on top of each other(so one drives the other)

[alan b]

it seems to have stopped now but seems abit slower could its still be not working?