help-e/w + oil pressure switch

[Anonymous]

on my nova i have the mk.1 electric window motors and loom but iv fitted the mk2 centre console,pod and switches-the wiring is different and i think the mk2 switches use a different principal--does anyone know how i if/can wire them up using the mk2 switches or is there a different switch i can use that looks the same(same as in cavalier)because they look soo much better than mk1 switches?

the other thing is,is its a 1L and iv fitted the six dial clocks so i bought an oil pressure switch to get that dial working but it wont screw in, it hits the side of the block and i was wondereing if anyone knew what i could do or if there is an extension type bar/elbow that i could screw in then screw the oil switch into?

thanx for any help!!!

[Anonymous]

I think you can get whats called a t-piece from Demon Tweeks which basically screws into the existing oil pressure warning light (o.p.w.l) hole. This gives you two holes then...one for your o.p.w.l and one for the oil pressure sender which connects to your guage on the dash.