Anonymous
03-02-02, 07:49 PM
2day i put my new engine in put all my head,carbs(40's) on etc cars runnin but say eg its tickin over at 900 and u rev it, it dont go back to norm(900) it sticks at about 1800,checked all the linkages sprayed wiv wd40 there all fine and returnin. Could it b somin stickin in the carbs? if so wat, and y as it just done it when i took the head off then put it back on.
well this wats appen to me so far:
set out to change the lifters, when tighenin head bolts vauxhall go dont use a washer, then the bolt snapped took head off, got it recoiled, put head back on, timin was out inlet valve all bent head off again, bought new inlet vavles from blydenstien(not cheap) got the re cut, put head back on then found out that when they drilled the old bolt out metal got down the oil way and caused it to scor shells, so took head of again, got new bottom end, put that in car 2day put together, that seems ok but now revs stick was doin the previous times when i took the head of re built etc but not when it was goin before i started all tis nightmare.:(
well this wats appen to me so far:
set out to change the lifters, when tighenin head bolts vauxhall go dont use a washer, then the bolt snapped took head off, got it recoiled, put head back on, timin was out inlet valve all bent head off again, bought new inlet vavles from blydenstien(not cheap) got the re cut, put head back on then found out that when they drilled the old bolt out metal got down the oil way and caused it to scor shells, so took head of again, got new bottom end, put that in car 2day put together, that seems ok but now revs stick was doin the previous times when i took the head of re built etc but not when it was goin before i started all tis nightmare.:(