View Full Version : v6 brakes set up
raymond
10-05-07, 07:06 PM
ive just got some calipers for some v6 brakes now i know to use fiat coupe turbo disks but do you need the spiggot rings or something like that for them to fit or are they a simple swap over and everything will be ok
many thanks
Ye need some spigots.
And one hole needs elongating iirc.
raymond
10-05-07, 07:31 PM
:thumb:
i may be talking total **** here, but iirc correctly v6 are 288mm and turbo are 284mm, so you must use turbo pads otherwise the v6 ones will over hand by 2mm...
craig green
11-05-07, 10:02 AM
Or use the proper 288mm discs from Vauxhall which are ?50 trade club incl the right pads.
I dont want to spark off a list of what discs might work (again) but surely for the sake of ?6 or summat, it makes more sense to have the right pads & discs?
But the 288 disks are 5 stud. The Fiat disks are 4 stud and the PCD is VERY close...
So much so, I managed to get some on with only about 20 seconds of filing one hole..:)
lmf sell them in 4 stud for ?95
raymond
11-05-07, 06:58 PM
cheers mate
will f did you use the spiggot rings or not :thumb:
Philsutton
11-05-07, 09:01 PM
The fiat ones work fine, i use them all the time an have no problems. If you buy the vauxhall ones then yuo need to pay someone to re drill them. Plus i would rather not have about 6 million holes in my discs and you dont need the rings but it does make your life easier.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.