View Full Version : track rod ends..
greg1.4
07-05-07, 12:52 PM
i am struggling at renewing my track rod ends. any ideas how to get them off? i cant get them off the steering arm and i am worried i am going to round the nut as its rusted on..:confused:
cheers,
Greg
Just chop the nut of with a grinder, then knock it thru, Job done !!
Jon_nova1
07-05-07, 01:15 PM
nut cracker
i used a blow torch on them untill i they came loose
greg1.4
07-05-07, 02:59 PM
dont fancy taking the grinder to it..
i thought about putting the blow torch on it until it got right hot then trieng to get it off after that. think i will try that first.
cheers
dont fancy taking the grinder to it..
i thought about putting the blow torch on it until it got right hot then trieng to get it off after that. think i will try that first.
cheers
Id rather grind it than heat it up TBH.
greg1.4
07-05-07, 03:26 PM
but if i grind too far will i not damage the threads on the steering arm?
Ah, sorry, thought you were having trouble getting it off the hub carrier, not the track rod itself.
greg1.4
07-05-07, 03:35 PM
no problems. i am going to grind the nuts off the hub carrier then knock it through. i am struggling getting it off the track rod itself as you say.
You need a blowtorch/oxyaceltalene(sp) to heat them up to help get them off.
Its the reason garages charge so much to replace them.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.