how do i stop this from moving

[SRlew]

right i took it out once a few months back, i put it back in and it just flops around lol its funny but so annoying!
http://i6.photobucket.com/albums/y217/srlew/02052007298.jpg

its the one on the left i need to do, its just held in one place with a chewing gum wrapper lol

cheers, lew

[thunderpants]

could try a piece of magazine page folded up, if its laminated it'll last longer than the chewing gum wrapper, but it won't smell as minty

[Iain]

Not really a solution is it lol

Did you break the little clip bits on the top/bottom when you took it out?

[thunderpants]

is it upside down?

[SRlew]

dont think i broke any thing. and it wont isnt upside down as theres only one way it can fit IIRC

will check again that nothings broken tho

[mayhem]

same prob here. 1st time i took one out, en now the move to smooth

[Ernie]

If you take it back out it should have a little plastic bit thats round on the inside but has a square outer edge.
If the little bit is missing thats why it's moving about.
It's a bit hard to esplain it but will try and get some pic's sorted tomorrow.

[SRlew]

ah right nice one that'll ideal chunny

[rednova]

If you take it back out it should have a little plastic bit thats round on the inside but has a square outer edge.
If the little bit is missing thats why it's moving about.
It's a bit hard to esplain it but will try and get some pic's sorted tomorrow.

Nail on head etc etc :thumb:

[ade]

yeah - these bits get lost if you remove your vents - buggers to replace - just get a couplea bits of card or thick plastic sheet and cut it into a square to fit, thendrill / pop a small hole in the middle.

Alternatively you would try a small wad of bluetack in the hole - usually holds it in place...

[SRlew]

ah right might try a bit of blue tack then as it'll be hidden