Blydenstien!!

[Anonymous]

as u mite know i got a 1.3 blydenstien b+ head, any one know wat inlet valves he uses because i measured up a 1.3 valve and there bout 1mm smaller also the valve butt(bit like a penny) in my head is completly flat unlike the butt on the standard 1.3 valve has a sorta recess/dip in the middle, the reason is i need a new valve and hes shut at the mo so i cant ask him, and i need a new valve asap

[Anonymous]

He gets them made. Don't know who does them for him, sorry

[Anonymous]

sorted now finally got hold of him luckly he had just poped in the workshop when i rang, but i gotta ring him on wed then order them. found out all four were bend slighly but number one was the worst.