Torque settings - bottom end

[Ash]

Just re-fitting my crank and pistons, went to find my haynes manual and its gone! So does anyone know the torque settings for standard mains bolts and ARP conrod bolts please?

Also my ARP bolts don't need countersinking:wtf: is this normal?

[Adam]

The ARPs should need countersinking.
As they have a radius under the head iirc.

Haynes says:
Big end bolts
15mm thread length-28Nm
40mm thread length-25Nm, angle tight further 30deg.

May be different for ARPs/\ Check the instructions with them.

Main bolts-
50Nm, angle tighten further 45 to 60deg.