Mk1 Dash To Mk2

[Anonymous]

Ive fitted all the dash now but im having trouble with the heater switches. Ive got the Mk2 cables and connected them to the Mk1 matrix, the only problem is though that the cables move as i twist the switches. The cables do have some sort of plastic connector on which keeps them in place at the other end but i cant find out where to connect them too. I know this sounds confusing but if you've done this before you should know.

[Anonymous]

You Need the Mk2 Heater Matrix!

**************************
MY CAR WILL BE IN MAX POWER!!!
**************************

[Anonymous]

u dont need a mk2 heater matrix as ste did mine usin my existing mk1 matrix outer casin as this is where it clips on too. theres one clip either side which the cables clip into, this will stop ur cable movin ad allows it to swivel, just av a good look round its abit of an akward position.

[Anonymous]

this mod has now been perfected use 4 x 5mm tie wraps to hold them tight to the mk1 heater matrix

16v Nova - Toolkit, Trouble, Points and great expence all come as standard :)

2.0 16v back soon :D

[Anonymous]

i might use self tappers, cheers

[Anonymous]

nooooooooooo dont thats the mistake i did and i went straight into the heater matrix and water was pissin out everywhere opps.

[Anonymous]

yeh and it is very hard to remove the rear 2 x 7mm bolts that hold in the heater matrix cause they are half covered my the brake bar

16v Nova - Toolkit, Trouble, Points and great expence all come as standard :)

2.0 16v back soon :D

[Anonymous]

so u member then ste lol:D and u ad to cut the pipes ofthe heater matrix cause they were seized on.