fitting kit for 32/34 webber

[bonkars]

hi i am putting a 1.6 gte engine in my nova next week,but it is going on the32/34 dtml webber i have the webber but no manifold but i have been looking on the site and you can get a fitting kit mine has got a plate and other stuff with it but not sure if it will go on:confused: .if anyone has a picture of the plate needed would you send it to me would be appreciated. or if any one has one of these lying about will have it off you. thanks alot

[mikey14sr]

rectangular plate with an oval hole in it? four 8mm holes that line up with the carb mounting holes and two smaller ones on the edge of the oval?

[Adam]

You wont get a manifold that matches the gte head either.

[mikey14sr]

I will soon be working on that one adam.

[Adam]

I have plenty of pics of mine i modded to fit a sri head on my old engine ;)

[bonkars]

i have currently got a 1.6 head on 1.4 bootom end. so will i be able to get the fixing kit for this manifold cheers

[Martin]

i have currently got a 1.6 head on 1.4 bootom end. so will i be able to get the fixing kit for this manifold cheers

the Inlet goes on the to head so even if you had a v8 bottom end with a 1.6 head you have to customise? a manifold for it.. would probs be easier to get a set of twin 40s

[garyc]

The look like this http://cgi.ebay.co.uk/Weber-32-34-DMTL-carb-vw-golf_W0QQitemZ270098722035QQcategoryZ72205QQssPage NameZWDVWQQrdZ1QQcmdZViewItem#ebayphotohosting

Do you want to buy mine in my listing?

[pow]

http://cgi.ebay.co.uk/NOVA-GTE-SR-2-x-40-DELLORTOS-BOWYER-RALLY-RACE-WEBERS_W0QQitemZ150103485809QQcategoryZ10404QQssPa geNameZWDVWQQrdZ1QQcmdZViewItem

Like that manifold?