View Full Version : Whats the best way to fit these please?
Welsh Dan
09-03-07, 06:27 PM
http://www.xen0phobiak.f2s.com/novaload/tcabushes.jpg
TCA bushes. :)
bigbened
09-03-07, 07:15 PM
id use a vice
i tryed that but took ages. take it to a workshop they done mine for a tenner and took no time at all
tom reid
09-03-07, 07:19 PM
id use a vice
And plenty of lubricant, Vaseline's my favourite. :gay:
Plenty of KY and drive it in with a G-clamp....
Welsh Dan
10-03-07, 05:43 PM
Cheers guys.
washing up liquid, get a long bolt use a large washer thats bigger than the hole on the tca's a large 1" socket can be useful and obv the nut. put the bolt thru the bush with washer nut at the opposit end of the hole to the bush and just wind the bolt up, will pull it in.
mikey14sr
11-03-07, 01:14 PM
When I replaced mine for poly's I heated the tca up with an oxy-acetylene set, the old ones then flew across the garage when hit with a hammer! To get the original style ones in you either need to make up a tool as lashed described or get a friendly garage to use thier hydraulic press. Plenty of lube (I've always found fairy liquid best) is the key to getting them in.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.