View Full Version : rear bumper - de-texturing
bieransri
03-02-07, 12:12 PM
i want to remove the textured effect from my rear bumper, what grade paper should i use to flat the bumper with?
aswrally
03-02-07, 12:13 PM
build it up with primer filler then flat down with 600
bieransri
03-02-07, 12:15 PM
:thumb:
Yep.
High build primer from a spray gun fills the texture.
High build primer from a spray can doesn't tho.
bieransri
03-02-07, 01:32 PM
just been and got some, whats holding the rear bumper on?
two nuts on the inside of the boot, underneath where the boot latch is.
And a clip either side of the ends of the bumper
mikey14sr
03-02-07, 03:16 PM
^ Unless it's a mk2, there's two screws behind the edge of the sides.
bieransri
03-02-07, 03:23 PM
got the bumper off easily enough, started prepping it and applying high build primer n fook me it takes some coats
I put on about 8coats of high build from a spray can and it was still slightly textured on mine.
But spray gun stuff is much better.
Get some wip pics up :)
bieransri
03-02-07, 04:12 PM
ive put some up in my project thread :thumb:
erm - you could always TRY LOOKING AT THE STICKY AT THE TOP - how to smooth and spray a bumper!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.