PDA

View Full Version : Wiring loom 2.0 16v!!!


Anonymous
31-07-01, 12:25 PM
tooooooo many wires!!!!!!!!!!!!!!!

Can anyone tell me which wires are need on the astra wiring loom and what to connect them to on my car?????

(I have 1.6 GSi and am fitting a 2.0 16v engine from an Astra)

Nice car, what's the retail on one of those?
More than you can afford pal....Ferrari!

smoke him!
Anonymous
31-07-01, 01:17 PM
u have wiring probs? i am getting my ecotec today hopefully
Anonymous
31-07-01, 01:30 PM
lol! I wouldn't fancy getting one of those into a nova!!!!

Nice car, what's the retail on one of those?
More than you can afford pal....Ferrari!

smoke him!
Anonymous
31-07-01, 07:05 PM
Use the 16valve loom for all the injection gubbens, and for the water temp located on the thermostat. There will be a green wire coming from the ecu which is for your rev counter and a black wire at the passenger side of the infection rail for the switched voltage (ignition). There should also be a constant 12v wire which is the large red one.

I have had trouble with an earth on mine though as it seem to burn out if I try to turn the engine over (to start) for to long, but it doesn't start that easily with twin carbs.

If you have further problem (as my engine used a distributorless ignition and is on carbs) then checkout:

www.pngregion4.co.uk

This should hopefully help.
Anonymous
31-07-01, 07:05 PM
Use the 16valve loom for all the injection gubbens, and for the water temp located on the thermostat. There will be a green wire coming from the ecu which is for your rev counter and a black wire at the passenger side of the infection rail for the switched voltage (ignition). There should also be a constant 12v wire which is the large red one.

I have had trouble with an earth on mine though as it seem to burn out if I try to turn the engine over (to start) for to long, but it doesn't start that easily with twin carbs.

If you have further problem (as my engine used a distributorless ignition and is on carbs) then checkout:

www.pngregion4.co.uk

This should hopefully help.
Anonymous
31-07-01, 07:09 PM
Oh, and the fuel pump wires which sould be the same colour as the gsi ones I think.

You'll also need the relay in there. and small plug with the octane rating on it.

Loads of the wires won't need to be used so don't be alarmed when you have a handfull of wires but nowhere to put them.
Anonymous
01-08-01, 09:05 AM
your 16v lump, did you buy it off David ?

"what you mean I'm called Achilles and Ive got an Achilles heel, I'll be a laughing stock !"
Anonymous
01-08-01, 09:29 AM
Just a warning, the ecotec is a Bar steward to wire up. We had to get an electrician in!
Anonymous
01-08-01, 08:57 PM
cool
Anonymous
02-08-01, 08:53 AM
I got my engine from another bloke down in Luton.

Nice car, what's the retail on one of those?
More than you can afford pal....Ferrari!

smoke him!
Anonymous
02-08-01, 11:29 AM
and no he didnt get it from me lol
Anonymous
03-08-01, 07:19 PM
The race is on john! lol My engine is going back together this week as my parts will be here on monday or tuesday. Good luck john! Rick

WWWWWWWWWWWWWWAAAAAAAAAAAAAAAAAAARRRRRRRRRRRRPPPPP PPPPPPP