View Full Version : quick question on digidash....
staggy_gsi
07-01-07, 03:48 PM
im currently on with fitting my dash and have noticed that on the nova clocks there is only one tell-tale for indicators but on the digidash there is one for each direction. is there any re-wiring involved to get the tell-tales to work?? :thumb:
You need to join the wires to the ones at the indicator stalk, not the black/white/green dot wire in the dash loom.
staggy_gsi
07-01-07, 04:23 PM
rite.....
well im not the best at wiring so ill have a go and see what happens!!
cheers bud!
Take the lower steering shroud off and you'll see a black/white, and a black/green wire in the loom to the indicator stalk.
Splice them into your digidash loom.
The Simps
07-01-07, 04:47 PM
As said above. Not too bad a job mate.
Simps.
staggy_gsi
08-01-07, 03:17 PM
what, cut them and extend them up to the dash or just take a feed from them?
Take a feed from them.
DONT cut through the wire itself.
The Simps
08-01-07, 04:28 PM
You need to splice into like a " Y ".
You can either cut the wire and rejoin all 3 or the easier way is to trim back insulation and solder in the new wire then re-insulate.
Simps.
staggy_gsi
08-01-07, 07:58 PM
nice one, i think i know what im doing now lol
keep an eye on my WIP thread to see if i manage to break anything!! lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.