View Full Version : Nova GSI clocks
vauxhall_mechanic1
28-12-06, 02:07 PM
Hi there im trying to put some GSi clocks into my J reg Nova (c12nz). evrythin works apart from the rev count as there is no wire to it, any idea where i can pick up a signal from to get it to work??? eg distributor,coil etc???????
Didn't you ask this the other day ?
You should know anyway, seeing as your a Vauxhall Mechanic !?! lol
Rich
ive just put a set of gsi clocks in my j reg nova, they plugged straight in, the rev counter wire is in the black plug, thatrs all you need to plug in
if that doesnt work then the wire might be broke or the clocks might be fooked
jope this helps
dave
o and you are plugging mk2 clocks in arnt you lol
I thought rev counter wire was green? lol
Wire from the coil should do it.
vauxhall_mechanic1
28-12-06, 05:42 PM
o and you are plugging mk2 clocks in arnt you lol
Right, the wire which runs the Rev count is missing, maybe because the car i was putting it in does not have a rev count? i dont know, i am putting the GSi dials in my mk 2 J reg(C12NZ) but i tried them in my mates H reg (12ST) mk2. The multi plug in the back of the dials fits all correctly and it runs everything, apart from the rev count, i can see why because there is no wire in my loom to support a rev count. Yes i am a vauxhall mechanic but iv never worked on a nova because we never get them in as i work for a main dealer lol
ok, go look at the loom, there should be a lime bright green wire, this is the rev counter wire, if this is on your plug and it still doesnt work you must have broken clocks mate
vauxhall_mechanic1
28-12-06, 05:53 PM
no this is what im sayin, there physically is no rev count wire in my loom, i can see exactly where it would go though,if you look at the connector there is a pin missing (the rev count one) i was just wondering where i could pick up another signal from??
Bottom right spade terminal on the coil.
Run a wire from there to the tacho pin on the plug.
Some novas dont have the tach wire in the plug as std, but others do.
stuartp
28-12-06, 07:36 PM
^^^^ excactly Right!!
i just ran a new wire all the way from the green wire going into the coil to the back of my dash! then put a spade connector on it to the seperate terminal on the dash!
have you got the oli pressure gague all sorted then?
Novadex
28-12-06, 09:58 PM
i told you all this the last time you posted!
WOO! 600 posts
vauxhall_mechanic1
30-12-06, 04:28 PM
yea oil pressure works fine
BigStan
30-12-06, 04:42 PM
Shouldnt this be in mechanical ?
Novadex
30-12-06, 05:25 PM
yes, thats why i think it was removed the first time it was posted
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.