View Full Version : GSi clocks
vauxhall_mechanic1
27-12-06, 02:52 PM
Hi there i have a J reg Nova 1.2 (C12NZ) (which does not have a rev count as standard) and im trying to put a nova GSi dash. The new dash goes in and everything works APART from the rev count (as there is 1 wire missing out of the loom which clearly runs the rev count) any ideas as to what i should join this wire to get the correct rpm signal?? eg coil, distributor? any help appreciated
Bottom right terminal on the ignition coil.
Run a wire from there to the dash.
It most nova's its already wired tho, it was on my 1.2
yea usually a green wire on the novas ive had if that helps!
craig green
28-12-06, 03:19 PM
make sure the speedo cable is moved over inline with the L/hand mounted speedo in the GSi clocks & not centrally as per poverty spec speedo.
vauxhall_mechanic1
28-12-06, 03:55 PM
oh right, cheers for that much appreciated!!!!!!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.