help!!

[CLEMMY1]

ive got a 106 xsi the drivers side rear wheel cylinder needs replacing. only problem being the drum wont come off now it spins freely,handbrake is off etc. tried everything even broke a slide hammer tryin to get it off. is there anything that you have to do? and little clips or anything? any help at all would be good thnx jayson

[Nobby]

lol mite be stating the obvious but have you took the nut and bearings out of the middle under the grease cap??

[CLEMMY1]

yes lol have done all that but still wont budge

[Adam]

You sure its not got a small screw holding it on?

[CLEMMY1]

yeh im sure

[bigbened]

i thaught id taken everything off when i did my missus 1 but i hadnt, check the haynes just to make sure

[Stuart]

i had to do that job ona 106 and the drum was sufficiently worn that it wouldnt slide over the shoes. so i loosely bolted the wheel back onto the drum and ripped the bastid off

[CLEMMY1]

oh ryt try that later then, if not were going to heat it up and rip it off. thnx for the help

[bigbened]

you can undo the shoe tensioner bolt things through the heles uf you want but i didnt bother. as was said just put the weel on and wiggle and kick as hard as you can