A Couple of things!

[stuartyhall]

1. Where are all the bits holding on the front and rear Gsi bumpers?
2. How to get the back part of the gsi skirts off?

Cheers

[benny f gsi,n it]

hey, the gsi side skirt is held on with 1 clip at the bottom a line of sticky tape, and 2 plastic pop rivest in the end. drill out the plastic rivets with a small drill bit and pull off slowley top to bottom then unclip the bottom clip!!

[James P]

get a torch and look under the wheel arches for 2 13mm bolts about 5cm away from each other for the frnt bumper,

the rear is held on with 2 bolts on the inside of the boot.

there are plastic things on the sides of the bumpers that keep them straight thaat your have to take off aswel

[Iain]

Remove two small screws on each side (both front and back) holding the bumpers on to the front wing/rear quarter.
Front bumper iron with bumper can be removed from their mounts by removing the grille and 2 small bolts behind the bumper.
Rear bumper can be removed with 2 bolts in the boot.

[Asa-James]

i found hitting a hedge at 50 is a good way of removing the front one...

[Stanley]

i found hitting a hedge at 50 is a good way of removing the front one...

Bahahaha class LOL

[Asa-James]

http://s87.photobucket.com/albums/k155/asa_037/th_15-09-04_0826.jpg (http://s87.photobucket.com/albums/k155/asa_037/?action=view&current=15-09-04_0826.jpg)