View Full Version : Welded engine bay
hi all..
recently had my bay welded up.. i was woundering what primmer should i use on it ??
also how should/could i go about smoothing the bay? filler fibre glass?
Cheers martin:thumb:
i wouldn't use filler or fibreglass it will just crack when driving with the xe
Just grind the welds down so they look nice.
Then spray over with normal primer/zinc primer.
lee coley
04-11-06, 01:46 PM
Tidy up the welds with a grinder, use etch primer on bare metal, then use a 2pack hi-build primer,the etch will etch into the bare metal u can put the hi-build primer over the top of the etch with out flatting it.
owt else just ask!
grind welds down like said, but imo i would put some seam sealer over the top too
lee coley
05-11-06, 12:39 PM
What will seem sealer do? theres no seam to seal it can look a mess when just put on all over.
If the welds are neat then paint over them.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.