View Full Version : scuttle panel
General Baxter
04-10-06, 02:49 PM
if i flush this, would i have to build a pipe going to the heater fan to the out side?
or will it draw the air from somewhere else?
Theres a hole each side of the battery tray panel, that allow water to escape down the inner wing and out to the floor.
General Baxter
04-10-06, 02:52 PM
oh are lol
DIY*VALVER84
04-10-06, 02:59 PM
you chaps sure them holes are big enough?spoke to ppl b4 who have smoothed the scuttle and they had to chop some of the firewall off, its only like an inch all the same. or you could do what austin did,remove the top part of the bulkhead completley,
Welsh Dan
04-10-06, 04:11 PM
Make a mad max styled fake supercharger intake :D
http://www.xen0phobiak.f2s.com/novaload/madmaxscoop.jpg
or how bout you just leave 3 or 4 slots for ventage?
It'll be fine.
Lead fill it though as the P38 will sink.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.