No Sound

[matt1chelski]

Ok, i got a panasonic headunit, with 6x9 rears and std front seakers. All was fine, then i got in it the other day, and there was not sound. Everything else works fine, screen CDsRadio etc, theres just no sound. Net even the bleep noise to tell me to take the front off. :wtf:

Any ideas
cheers
matt

[Jack]

checked all the cabling to the speakers?

[Phil 55]

Possibly a speaker cable trapped to earth (bodywork) wich will cause the radio amp to go into "protection" mode to prent damage.

[Lucky Luke!]

Check all your speakers, ( more than likely a door speaker ) if all is good from what you can see disconnect each one, one at a time. If still no joy your internal amp is ****ed!

[matt1chelski]

Well all the wireing is std, i checked the wiring in the dash, am going to bung it in my dads car and see if it works or not,

cheers
matt

[matt1chelski]

Ok, it must be the wiring, the headunit worked fine in my dads car. So, any ideas what wire goes to what speaker? (std vaux fitment)

Thanks again