fitting door

[L14MNP]

I have a door that requires changing, unfortunately the new door i have (painted now) is completely bare except for a manual window reg (which is of no use to me)

How much of a **** on is it to fit everything into the bare door, I guuess i have to rivett the window reg back in, how hard is it to remove the front quarter glass etc?

Also what do you guys use to remove the door pins? IIRC I took a mates door off years ago and we used a cut down bonnet stay i think...

Cheers, Liam

[rednova]

easy to swap everything over bud, just unscrews mainly, buy a door pin removal too from any motor factors (about ?15) saves loads of time

hth

Phil

[hendrix]

yeah you need to drill out the rivets holding eveything and then simply just re bolt everthing in. 1/4 light comes out dead easy too

[L14MNP]

Cheers lads! Will attempt this at the weekend, at least this aint a job I can just leave half done, so no choice lol