bolt for water cooled weber manifolds

[total_vauxhall]

dose any one know were i can get the bolt that screws in the back of the manifold for weber carbs that the water pipe connects to from the heater matrix

[Mike]

Do you mean this>
http://i80.photobucket.com/albums/j181/mikenova/PICT0067.jpg
on these>
http://i80.photobucket.com/albums/j181/mikenova/PICT0068.jpg

[Welsh Dan]

Find out what thread it is, and what the inner diameter of the tubing that goes onto it is and finding a barb like that should be fairly easy in any half decent plumbing supplier.

[Philsutton]

on my old 2lt 16v manifold I had to buy one from SBD i think it was. There are two i think, a little one which went to the header tank and one big one on the back underneth, but thats what was on mine.

[total_vauxhall]

i lent one off a friend that fits but he needs it so i tuck it round loads off pluming shops but couldnt match one up so iv sent webcon an email i think the sell em. cheers for the advice

[dan23]

put 2 jubilee clips on the hose an screw them tight it works fine