oil cooler

[Anonymous]

hi guys i have a 2.0l 16v engine out of a cavalier g.s.i which had an oil cooler on it but i want to temporaily remove it until i have enough time to instal it in the front bumper this is so i can use the car in the mean time. I have unbolted the oil cooler from the oil filter housing but do i have to remove the housing? if so how do i fit the oil filter back on? or how do you plug the holes properly?

[Anonymous]

remove the 22mm (i think) piece of threaded bar from the the oil cooler take off plate and fit the shorter pipe from a non oil cooled 1.6/1.8/2.0/2.2 ithe pipe will have to be bought new as it is damaged during removal so a second hand one can't be used


--- Novaload technical support open 24hrs ---
--- Phone/SMS Support 24hrs ---
--- Workshop services 6pm - 11pm Mon - Fri, 9am - 11pm Sat/Sun ---

[Anonymous]

Can you remove the pipes from the oil cooler and just connect them together with the correct adaptor, so you just have a loop of pipe ready for the cooler at a later date?

Plese don't let busses pull out.

[Anonymous]

short piece of threaded bar is only a couple of quid from vaux
and if you loop the pipes you may have problems!

--- Novaload technical support open 24hrs ---
--- Phone/SMS Support 24hrs ---
--- Workshop services 6pm - 11pm Mon - Fri, 9am - 11pm Sat/Sun ---