Gearlinkage connecting pin

[Adam]

Got the F15box bolted to my 1400, but it seems the F15 uses a bigger pin where the linkage joins the box fork.
So i have a lot of movement in the pin which i dont think i had before.

Any ideas if i can just change the pin for a bolt? That fits the hole better?
Or does it need to be a pin? Lol

[General Baxter]

just get an F15 pin

[Adam]

No.
I dont have time.

[General Baxter]

erm long bolt?

[Adam]

Thats what i was thinking, but will a bolt allow the linkage to move right.
I might just try it tomorrow,Lol.

[General Baxter]

drill the linkage out to the diameter of the f15 hole and find a bolt that bit snug into the linkage

[craig green]

Any bolt with a Nylok nut should sort it. Fill any gap (play) with thin washers to keep her tight.. ooh err

[Adam]

K mate, cheers.
I'll put a good fitting bolt through the hole.

[stafford]

hi mate i got an f15 on mine i used my original linkage didnt have those problemes

[Adam]

I think i damaged the pin removing it,Lol.
So now instead of it being tight, the fork can move about.