Stainless system

[BigStan]

I have purchased a stainless steel exhaust system for a 1.3 SR and i need it to fit my GTE !

How can i make it fit ?

Cheers

[Adam]

Cut the flange off the front section where it joins the downpipe, and then extend/weld it in the angled position to meet the GTE downpipe.

Or fit a SR downpipe/manifold.

[BigStan]

would the holes on a SR manifold/downpipe be different to a GTE one ? From either the head or the bottom of manifold ?

If i bought a Manifold and downpipe from an SR would all the holes match up on the head, and would the be anything obstructing it if fitted ?

Cheers

[Adam]

Should fit fine, ports on the head are the same.
And the Sr downpipe should bolt right up to the SR front section.

If you have a GTe you shouldn't have a lambda, so thats no problem either.

[BigStan]

Thanks very much !

[Adam]

Should be fine, im pretty sure the gte doesn't have a different sump or anything, so the sr downpipe should fit fine.
I have Sr exhaust and manifold on my 1200, fits fine.