where can i get these parts for dellertost40

[dan23]

i am after the following for a pair of twin 40 carbs
7772.3 emulsion tube
115 mains
160 air
7850.2 idle

[garyc]

http://www.dellorto.co.uk/

[Adam]

FastRoad, or i think EuroCarb on ebay may be able get them.

http://www.fastroadcars.co.uk/store/index.php?PHPSESSID=2f03500769e4b600a9a0736af97ebc 7e

[garyc]

Also if this is related to the thread about your carbs not running I would be tempted to get what you have running then getting it re-jettted properly on a rolling road. Even if your jets are way out when engine will still run.

[womble sri]

and 160 air jets will prob make it run lean best to get your jets grom the RR because then you can see which ones are best before you buy.

[dan23]

steve gault told me to that spec ,ages ago i just found the piece of paper with it wrote on ,so do you u think 160 will make it run lean i am okly using the 1.4 sr cam it doesnt have loads of lift like the after market ones ?

[tom_beverley]

Eurocarb or Fastroadcars on Ebay.

If you give them the setup of your engine, they will advise the right parts aswell!

[dan23]

fastroad only do weber an eurocarb dont list any dellorto parts either

[tom_beverley]

If you contact them, I'm sure they will be able to get them :thumb:

[womble sri]

yeah they will no worrys. SG knows best so it prob wont but your better of selecting your jetas at the RR where you will be able to try before you buy if you get what i mean

[garyc]

He really needs it on the rollers, what works for 1 engine may not work for another. Also wasnt there a bloke on here who holed 2 pistons with "reccomend" jets from fast road cars???

There sounds like there is a fundemental problem with his set up chaning jets wont get it running unless they are all blocked.

[tom_beverley]

True, rolling road is best.

Something must be wrong since even if it is currently setup badly it still should run to a degree shouldn't it?