theshandydrinker
31-05-06, 11:36 PM
hi guys,
clutch went tonight and i need it for work friday, the box is out, just want 2 double check 3 things:
i am replacing my 4 speed box witha 5 speed, i have used all the old gear linkages, rods,selector etc except the small box already bolted to my 5 spd box will this be ok?
i usually use a clutch alignement tool, align the clutch and tighten the bolts on the diaphragm but with the new clutch, i have tightened all the bolts fully to the flywheel but the clutch plate is still moving loose in the pressure plate! will this be ok as long as can get the box on and the spline through it?
the box is off a carbed engine, will my single point injection starter motor fit ok? as the two are different i think! thats about it! any help would be aqppreciated! cheers in advance
clutch went tonight and i need it for work friday, the box is out, just want 2 double check 3 things:
i am replacing my 4 speed box witha 5 speed, i have used all the old gear linkages, rods,selector etc except the small box already bolted to my 5 spd box will this be ok?
i usually use a clutch alignement tool, align the clutch and tighten the bolts on the diaphragm but with the new clutch, i have tightened all the bolts fully to the flywheel but the clutch plate is still moving loose in the pressure plate! will this be ok as long as can get the box on and the spline through it?
the box is off a carbed engine, will my single point injection starter motor fit ok? as the two are different i think! thats about it! any help would be aqppreciated! cheers in advance