View Full Version : What single wiper arm to use
nova---chris
23-05-06, 08:08 AM
Just wondering what wiper arm people use on a single wiper conversion?
Looking for a better alternative to a crappy standard nova one lol!
Any ideas then??:thumb:
early pug 306 smooth wiper arm on an adapted nova linkage!
looky looky >> http://www.novarally.co.uk/ (http://www.novarally.co.uk)
check out the mods section
I have a 306 rear wiper with a 19" blade, but had problems when fitting it, the arm isn't as long as the nova one so the bottom edge of the blade sits to far down the screen.
So i just re-fitted the standard straight arm that came with the wiper kit, looks the same as a standard nova one.
The pug one looks hardly any different to a std nova one tbh.
Heres the 306 wiper i have:-
http://i10.ebayimg.com/05/i/07/18/ab/79_1_b.JPG
Rick Draper
23-05-06, 03:34 PM
Thats a different 306 wiper to the one i have. I will get you pic's of my one later on chris as going working on the car.
Thats a different 306 wiper to the one i have. I will get you pic's of my one later on chris as going working on the car.
Im not sure if mines off a ph1 or ph2 306.
I think my arm is off a ph1 306. It has washer jets built into the wiper
I saw a t-reg 306 today, and that had like a smooth plastic arm. Looked cool.
So that must be a ph2 wiper.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.