beavy69
19-05-06, 02:44 PM
I can't think of anything else simple it could be before I rip the carb apart to check all that.
1.3L with webber 32/34.
Starts fine from hot.
Starts just about 5 hours later, but doesn't respond to throttle on first part of pressing the peddal and is quite hesitant until it warms up again.
I have swaped and cleaned dizzy caps and HT leads and checked plugs.
It turns over and fires from cold but just wont quite start. I have tried playing with idle mix screw and choke and all else is set as in the Haynse carb manual.
Problem is I have to wait overnight to see if a change I have made does anything as it will normally start on the same day when hot:wall:
I'll post my jets asap when I find where I have written them lol
Any ideas anyone?
1.3L with webber 32/34.
Starts fine from hot.
Starts just about 5 hours later, but doesn't respond to throttle on first part of pressing the peddal and is quite hesitant until it warms up again.
I have swaped and cleaned dizzy caps and HT leads and checked plugs.
It turns over and fires from cold but just wont quite start. I have tried playing with idle mix screw and choke and all else is set as in the Haynse carb manual.
Problem is I have to wait overnight to see if a change I have made does anything as it will normally start on the same day when hot:wall:
I'll post my jets asap when I find where I have written them lol
Any ideas anyone?