View Full Version : 1.6 (e16se) GTE engine in to either 1.2 or 1.2i
i have a tidy MK1 1.2 carb getting some welding done this summer on arches then she's a pretty good shell, going to put a 1.6 in as im 21 end of the year and need/want something a bit faster/fun. list of part i think i need/knwo i need an anyone help me finish the list so when i come to swop it over im not missing anything
Engine
loom
Exsturst
ECU (mk1 or mk2 )
dails
tank or full pump?
thanx People just get out and drive
alistairolsen
13-05-06, 08:27 PM
mpi tank and pump
loom and ecu from donor engine
manifold/downpipe from donor should mate to any aftermarket system
any dials will do, unless you want revcounter ones. You might have to run new tacho wire.
Welsh Dan
13-05-06, 08:55 PM
I had some trouble finding a 6-dial set for a mark 1, if the donor car is a mark 2, consider fitting its dash aswell, as the wiring+fitting is different for the dials.
You'll need to run new fuel lines too, the carb one is low pressure, and has no return. The mpi ones need a return hose, and a much higher pressure. If i remember correctly, you can use your existing line from the carb as the return line though.
The 1.2/1.3/1.4 carb engines have a return line, its only the 1L that doesn't.
Ye, it is recommended to swap the lines, but i know a few people that haven't.
Think you will need new driveshafts, as the gsi/gte ones are different? Someone else will need to confirm this though as im not 100%
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.