Adam
28-04-06, 03:47 PM
Started fitting a single wiper today, but that didn't go to plan.
So just thought i would wip the std ones back on.
After fighting with it for about an hour i realised the wiper spindels had some how turned round, stopping the linkage from fitting right :roll:lol
So i sorted that.
But now when i turn the wipers on, the blades move down about 1" and then go up and wipe as normal.
Why are they moving down??
I've had to set the wipers about 4" up the screen so the wipers dont go off the bottom of the screen when i turn them on.
Any ideas ? lol
So just thought i would wip the std ones back on.
After fighting with it for about an hour i realised the wiper spindels had some how turned round, stopping the linkage from fitting right :roll:lol
So i sorted that.
But now when i turn the wipers on, the blades move down about 1" and then go up and wipe as normal.
Why are they moving down??
I've had to set the wipers about 4" up the screen so the wipers dont go off the bottom of the screen when i turn them on.
Any ideas ? lol