Digi dash in mk2

[terrible___1]

Im getting a digi dash next week ive got the wiring diagram but how hard is it to fit where the normal dials sit?


cheers rob

[Adam]

Need to cut the lugs off iirc.
But it should basically fit straight in, might need a bit of jiggling.Lol

[graham kirkbride]

:thumb: hi mate its not hard to do but you need to take your time and trim bits away bit buy bit on your dash under the clock surround until they fit all i can say is take your time it will fit also you have a wiring loom running behind the clocks you need to cut the tie rap that secures it and move it back abit for clock clearance as the digi dash clocks are abit deeper best to leave it loose until your happy with the way the clocks sit with the clock surround on then secure the loom again with a tie wrap also you have to wire the indicators on the digi clocks into the indicator stalk on the steering colum because there is a right arrow and a left arrow on the digi clocks unlike on the nova clocks you can get to it buy removing the bottom black plastic casing from around the steering column three screws i think are under neath and there is one either side of steering wheel also disconnect car battery before you wire it up and connect earth from clocks to the nova loom and check each individual thing on the clocks works ie handbrake light, oil light, indicator,left & right, hazard lights etc etc hope this helps mate

[terrible___1]

cheers for the advice lads should have them fitted soon.