View Full Version : can nova throttle cable be used on t40s
its seems that if cut the nipple off the end of the standard cable it will work not sure about the lentgh of it though has any 1 tried this
aswrally
05-03-06, 10:13 PM
thats exactly how i ran mine when i ran twin 40s on my 1600
how did u make it fit mate?
aswrally
05-03-06, 11:34 PM
i cut the nipple off and threaded it through the linkage
then used a solderless knipple on the end
depends on the linkage you have
i have maguard linkage i think thats whats its called its has a bracket for two cable
can u do similar thing for the chokes ?
womble sri
06-03-06, 11:21 PM
i used one from my sri just trimmed it down but mine has got a nut so i just tightened it round that it holds fine but could really do with a decent cable. i took my choke off
can u do similar thing for the chokes ?
You dont need the chokes.
You don't need to use both throttle cables either.
I just have one throttle cable pulling dual linkages and it's absoultly fine.
However im getting it rebuilt and i may as well use both of them this time
so you need cut the outer cable to get the cable to pull properly how much do u cut off a rough guess?
think i ll use a barrel adjuster off motor bike an pinch bolt to pull cable through
i d like to use chokes i was thinking of use a cable an yoke from old cantilever mountian bike brakes an connect it to choke cable?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.