problems fitting 1.3 head to 1.4 botom end

[dan23]

on the 1.4 there are 2 pipes that come of the manifold an to the crank shaft ventilation box thing (its like a small black box under the inlet has gm stamped on it )

the 1.3 only has 1 pipe that goes to it its the bigger pipe of the two can i just block the narrow pipe off?

[mikey14sr]

that little black box is actually a breather/catch tank for the oil, the larger pipe normally goes to the air filter, and I've never seen the smaller one down there.

[dan23]

its deffo there on the 1.4
the 1.3 just has the one large pipe

do u think it will be ok 2 block off the small one

[dan23]

how about if i fit the 1.3 catch tank to the 1.4 bottom end so i lose the small pipe

are all catch tanks the same

[Jon_nova1]

doesn't that go into the back of the inlet maniofold?

[dan23]

not sure if it goes to head or inlet think it was inlet but if i use the 1.3 inlet i dont think it has the conection for the small pipe that come sof the 1.4 breather/ catch tank cos the 1.3 only has the 1 large pipe