help needed quick. brake lines stuck on the servo

[SRlew]

right just been out to swap my servo and i can only get one of the lines undone. all the other 3 are f**ked and carnt get them undone cause somones rounded them:mad:

whats best to do now then? is there a joint in them a bit further done the line so i can just replace the top part or not?

what shall i do? cheers, lew

[Stuart]

heat + mole grips.

OR jsut change the servo while keeping the same MS lol

[SRlew]

heat and mole grips sounds like a plan!
just gotta find a blow tourch or sumin now.

good thinking mate!

[Stuart]

I will smoke like a mofo and you WILL need to bleed the entire system too ;)

[SRlew]

well it'll be worth it i hope. i take it i'll go threw a fair few bottles of brake fluid then.

[Adam]

Why are you swapping it?

[SRlew]

mins got a slight hole appearing from rust, and i got a GSi servo and master cylinder to replace it. better than my SR one.