AX wiper motor conversion

[Jon_nova1]

I've just changed my crappy half windscreen wiping single conversion for an AX wiper motor, it works...which is good, the motor goes right when you do the screenwash thing, put it two slow constant and put it to fast constant, although the relay isn't connected i assume, as when you turn the wipers off they stop at that time instead of going to the right position, although this may be good if i time it right i can get it wherever i want

anyway, the question is, does anyone know what colours to wire to what, any ideas or diagrams?? cheers:D

[Adam]

Hmm, what are you doing?
Making a single wiper with a Citroen AX linkage/motor?

[Jon_nova1]

yes, i've got it all fitted and partially wired up, it was quite easy to do, i turned the motor around on the linkage assembly because it caught on the thingy (supports and panel behind the dash) i had to put the mount on the assembly at abit more of an angle and had to screw it into the bottom of the scuttle (where the nut and bolt it) using the original AX nut and bolt hole.

http://img.photobucket.com/albums/v166/Unicorn007/nova/DSCF0038.jpg

http://img.photobucket.com/albums/v166/Unicorn007/nova/DSCF0037.jpg

the plastic nuts on the scuttle need to be cut to the right angle so it fits right yet.

[Jon_nova1]

I know what i need to do :D

they'll be a constant live going to the connector, all i need to do is wire this to the connector on the wiper motor that has the contact on the cog inside with the gap so it stops where its meant to be :D