where can i buy twin 40s?

[JAMIEP]

Any1 know where can i buy twin 40s from new?? did look on the weber site but i dont know if they were priced each cos it was only ?200?? cheers

[beavy69]

there's usually some on ebay every now and then. Sometimes people sell the lot (manifold bracket ect) all together.

[Stuart]

sales@fastroadcars.co.uk I use them for weber bits and he sent a letter through saying that they can do new carbs now the factory has fired up again. Thing its they arent ?200 a shot lol

[womble sri]

http://stores.ebay.co.uk/Eurocarb-Ltd-Dellorto-Weber-Carbs
http://stores.ebay.co.uk/FAST-ROAD-CARS
both ebay shops got all linkage a parts ect

[CorsaCruiser]

On Ebay, (http://cgi.ebay.co.uk/Twin-Weber-40s-Vauxhall_W0QQitemZ8029945427QQcategoryZ72205QQrdZ1 QQcmdZViewItem) complete set with manifold and irmscher inlet. (used)

[Nick]

a local shop to me RSM (road and stage motorsport) can get new Webber carbs.

Saw a set in the last time i was there - spanking new, approx ?300 per carb.

PM me if you want the number, great service and they do mail orders.

[JAMIEP]

lol i didnt think they would be so much! have seen a few on ebay.....its a lot to spend on a 1400 tho......could get a redtop for that kinda money! iv been quoted a grand to do it if i supply an astra cavalier etc...is that good?? cheers

[Nick]

lol i didnt think they would be so much! have seen a few on ebay.....its a lot to spend on a 1400 tho......could get a redtop for that kinda money! iv been quoted a grand to do it if i supply an astra cavalier etc...is that good?? cheers

no not really - Labour wise it's about ?250 worth of welding,spraying.. then not much fitting.

I'm sure if you contact some nice people from here - you could get it done for less

[Snowface]

www.tuning.co.uk do i think. (I know they do DTML)