View Full Version : plastic cam belt cover can it b left off
cant undo crankshaft pulley bolt it jus turn round even wi car in car an brake being prssed can i jus cut the plastic cover off so i can get 2 water pump
how important is the cover
you can leave it off..
some say keep it on but tbh if your not going to be living on a gravel track/sitting in the run off at the track its fine...
lots of motorsport/rally folk leave them off.
do i need 2 make note of an timing marks on the cover before i cut it off or r the same marks on block head etc
i jsut used the pin on the block for TDC marks and ignored the cam marks as i was timing up different to STD anyway lol
S_Gault
01-01-06, 09:44 PM
jam the flywheel so you can take off pulley
lemon curd works too..... :lol:
Snowface
02-01-06, 10:51 AM
or an air rachet will get it off most of the time.
Mark Beeson
03-01-06, 12:59 AM
I think I call that the Bastastard bolt!
womble sri
03-01-06, 01:55 PM
leave it on just takes a stone maybe unlikely but if it did happen you would be kicking yourself
Safer with it on, then again I drove round for a year with no cover and had no problems, play the percentages!
slammed saloon
03-01-06, 08:32 PM
take the king lead off coil get a half inch breaker bar with 17mm socket on put it on bottom pulley nut wedge the bar aginst the floor and spin engine over thatll do it :lol:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.