View Full Version : 1.2i to a 1.2carb
Rite i know most of you are goin to tell me not to bother but my engines f**k'd and my m8s got a 1.2carbs nova and he maybe changing his engine and has offerd me his,,, and i was just wondering what would be needed to be done to swap engines.. and were can i get a set on brand new twin 40's.
Cheers In Advance
Martin.
Jon_nova1
29-12-05, 09:35 PM
well i only found out today that my carbed 1.2 nova was registered as an injection and the only carb part is the actual carb, the cylinder head was for the injection, but it worked exactly the same :o
thanks but am talkin about the whole engine swap not just the head n carb....
i changed my 1.2i to a 1.4 sr engine and i had to change.....
the fuel tank
the engine (obviously)
the wiring harness
that was everything i think!
hope this helps martin!
cheers karl m8... need 2 find out how 2 link the choke up and all that...
ooooh another thing is the throttle cable!
well i only found out today that my carbed 1.2 nova was registered as an injection and the only carb part is the actual carb, the cylinder head was for the injection, but it worked exactly the same :o
Well, you cant use a 1.2carb with a 1.2i inlet and cylinder head, it wont fit.
You probably have a SPI engine, not a carb one.
If your airbox has two bolts holding it, then its SPI.
If its 3 bolts then its carb.
he's got a square port head, but has a carb inlet with carb on, i've seen the carb, it has 3 bolts :wink:
he's got a square port head, but has a carb inlet with carb on, i've seen the carb, it has 3 bolts :wink:
Hmm, may i ask why? :? lol
The square port head will be loosing him power, and the carb inlet wont fit the head right unless hes modded the inlet manifold port shapes.
thats how he bought the car... and didn't know till the engine was striped
Cheers for the info lads... it dont really matter now i've got the hole car
http://www.novaload.net/features/viewfeature.php?ref=3177
Just need a rear axle
Jon_nova1
30-12-05, 07:36 PM
Yes, i know it'll be losing me power, thats why im hunting down a 1.2 head :cry: and nearly wet myself when i got offered one for 50 quid :roll: , i bought the car and noticed it had the square ports the other day quite by mistake when i had the head off and just happened to notice how small and square the ports were, it does fit, its just a crappy fit, the ports are too small and they're off centre :?
The 1.2carb bottom end is different to the 1.2spi one.
The bore size is a lot different IIRC.
I dont know how well it would run with a 1.2carb head on a 1.2spi bottom end(is the block a 1.2i?)
It might actually just be a 1.2i head on a carb bottom end.
Jon_nova1
31-12-05, 11:25 AM
I assume mine was a 1.2i engine and someones just put a 1.2 carb and manifold on :o
I assume mine was a 1.2i engine and someones just put a 1.2 carb and manifold on :o
See what the engine code is
Its on the top edge of the block as you look down into the bay. Near spark plug 4
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.