View Full Version : Removing ignition barrel??
I'm swapping a lockset of an old Nova I have onto my GSi, so I only have 1 key instead of 2!!! The locks were easily enough removed and replaced, but I'm lost when it comes to getting the ignition barrel bit out! Does anyone know how to remove it??
Thanks
Adrian
If you got a haynes manual its described with pictures in there, but u put key in and turn to click 2 i think it is an there is a little hole on one side near the back that a release clip inside i use a 2.5mm allen key an jus push it in and the barrel should jus pop out i think!!!
If you got a haynes manual its described with pictures in there, but u put key in and turn to click 2 i think it is an there is a little hole on one side near the back that a release clip inside i use a 2.5mm allen key an jus push it in and the barrel should jus pop out i think!!!
I have a haynes manual somewhere, but can't kind it at the minute!!!!!! I knew it was something simple like that, cheers!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.