Any ideas???

[Anonymous]

I have a white MK1 nova, with GTE grill, and front and rear bumpers (in standard grey finish) and grey GSi side skirts. Any1 got any ideas how I could make the front end look a bit "harder"??

Thanx

Phil M

[Anonymous]

splitter, mech grill, bonnet vents

RobDmr@aol.com
xr2 ??? i'd rather walk!

[Anonymous]

new front end ( bit pricey) Gsi front bumper?

dan69_gsi@hotmail.com :p

dangsi@novaload.org.uk :>
______
./__|__\?_
=|(_)___(_)\

[Anonymous]

Mesh the GTE grill and put a Ibiza splitter on and lower it 30mm, you can get just springs for about ?60

Ease Yourself Back Into Conciousness !!!!!
:D
I SHOT PHIL !!!!

[Anonymous]

If your handy with DIY you could cut out part of the bumper (extend the hole behind the number plate down to the bottom) and mesh it, evo style (have a look in last months rev's). I was going to do this to mine, but i'll be getting a bodykit put on in a couple of months.

B-) "and a Persian Rug" B-)

[Anonymous]

Have you thought of a metro(yeah metro,I know) vent on the drivers side of the bonnet?-Im well impressed by them at the mo,cos they are easy to fit,easy to get hold of,and can be free(if your breakers are a bit idle) Other than that,get a black sunstrip,dimma cap,slam the stallion and add a gte rear valance

[Anonymous]

you could get a bulls head with big pointy horns and stick in on the front of the bonnet, this would look reallllllly mean!!! lol :D

Mmmmm forbidden donut. :)

[Anonymous]

Erm... Well, ive just had 2 new front wings, and i prefer the look of the MK1. Its already lowered, I just wanted to do sommat different with the grill and the GTE front and GTE rear bumpers. I dont think a splitter would look very good, coz of the bit in the middle of the bumper which goes up a bit (u know what i mean), leaving a gap between the bumper and the splitter. Ive looked at doin this already - looks shite to me. I like the idea about enlargin the hole behind where the number plate is though - How do i do that???

Thanx

[Anonymous]

What about eye-brows, or doing the bonnet bad-boy style....or is this out of fashion already?

You could cut some rectangular spots in to the lower corners of the bumper, and put them behind mesh....I'm planning on doing that.

[Anonymous]

ow about cuttin the black spoiler at the bottom of the front bumper off an puttin the ibiza splitter on instead also get a set of corner splitters they make the front end look wider and lower.....

SORTED :D