Crossy
14-12-05, 05:28 PM
I have a 1.4 Sri and recently the Ecu went on fire.
Im looking to buy a Gte/Gsi engine to put in place.
I'll put the Gte engine in place.
So if i use the Gte loom, can i just cut back the burnt wires, put a new connector on then plug into the Gte loom ?
And will i need to change anything else for this conversion ?
Any help is greatly appreciated !
Im looking to buy a Gte/Gsi engine to put in place.
I'll put the Gte engine in place.
So if i use the Gte loom, can i just cut back the burnt wires, put a new connector on then plug into the Gte loom ?
And will i need to change anything else for this conversion ?
Any help is greatly appreciated !