R1 CARBS

[Ali's Valver]

Hia i have seen this done before. I have a nova c2oxe and i have a set of r1 carbs im just after some help please in sourcing the inlet manifold and any advice i did see an article in a mag a while back about this and it seem easy. Could somebody please show me the right direction. Thanks..

[m.d.]

you will have to make the inlet manifold mate, or get an engineering company to do it, i started to do it once but never finished,

get the manifold from your xe and cut off the manifold flange about 2 inches from the flange, then get a welding company to weld on 4 ally tubes at the correct pitch apart that will fit the carbs, you will have to do some match porting to get the ports to line up,

[aswrally]

try Bogg Bros nr York
they set my rally car up www.aswrally.co.uk made the inlet manifold for me and very reasonable email me for their no

[benji]

bog broscan make the manifold aswell. their number is 01944738234