-60mm on sr rims, arch work needed?

[Gistra-Nova]

Hey just had my car lowered 60mm all round, still on standard 1.2 wheel thingys. Well ive got some of those 3 spoke 14inch sr wheels to put on, bearing in mind its lowered 60mm im guessing the rear arches will need raising and rolling inwards, anything else needed?

Thanks.

[dunova]

Shouldn't need to roll them-although some nova's (especially the ones that have been in abit of a prang) can have the rear drivers/passengers rear wheel closer to the arch than the opposite side. Should be fine though.

[General Baxter]

mine dont catch even on full lock to lock, and its decked! front and rear :wink:


http://i11.photobucket.com/albums/a191/baxters83/IM000434.jpg

[Jack]

Tyre size could be an issue...

[Gistra-Nova]

What would be best to use 160 45 14?

[Philsutton]

they should not catch in my experience. Also baxter you have too may novas, an which one is that lol

[Jos]

I had mine lowered 60mm on the 14" 3 spoke alloys, never had any trouble at all

[General Baxter]

Also baxter you have too may novas, an which one is that lol

i dont know myself :lol:

[Ste_Nova]

185/60 14"

[womble sri]

my sri was lowereed 60mm on apex springs and shocks and i had 16" speedline allesios and they didnt rub 5's up over speedbumps although i did bottom out sometimes. i had no arch work but it was a minta it was completely straight as said if its had a shunt it may have less room on one side than the other