View Full Version : One peice rear bench to split rear bench???
ANDYRACER
04-09-05, 09:50 PM
I have a 1.2 nova fun with a single piece rear bench and was hoping to change to a sr interior but i believe the sr interior has a split rear bench. How would i make this fit or should i just get a GTE interior which i beleive has a one piece bench.
cheers Andy
gte's are 2 piece aswell,
you need to get the extra brackets and weld them in place
ANDYRACER
04-09-05, 10:08 PM
Oh bolloxs :evil: Cheers Ste looks like it is seat covers for me then :cry:
its only two brackets... not really hard, couple of spot welds and your sorted
ANDYRACER
04-09-05, 10:24 PM
Thats the problem i cant weld and i dont know anyone who can weld either. Could i screw it in? Ive not looked at the bracket so havent a clue.
on one, without looking, has a seatbelt bolt through it, thats the one that holds the back, could probably get away with out using the other two, that hold the base's, may move slightly though
dont even need to weld them, theyre held down with a bolt and a weld...
mines just bolted in
the one's that hold the base, might need welding in though, or just notr use them
ANDYRACER
04-09-05, 10:30 PM
Ill try and have a gander at my mates corsa (i ashume they are the same set up) and see if i can bodge it some how. Cheers Ste :wink:
dont forget your fuel tank is under the rear seat before you start 'screwing' stuff into it :lol:
ANDYRACER
04-09-05, 10:45 PM
Cheers i prob would have forgotten to check :oops:
You will probably need the bracket fitted as well, as i was told you car will fail MOT without it fitted as the seats aren't secure.
ANDYRACER
05-09-05, 01:26 AM
Ive had an idea, wat about rivoting the bracket into place :twisted:
yeah just pop rivit it into place. job jobbed
yeah just pop rivit it into place. job jobbed
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.