j1400
20-08-05, 04:30 PM
Removed the std seat rails in preparation for the box section to be put in for the buckets, I was using a 12" disk grinder so contorl wasn't all there, but it didn't take long, ears are still ringing now, managed ot go through to the outside world on the first on, so need to patch that when I put the rails in.
http://img373.imageshack.us/img373/958/im000755a1tb.jpg (http://imageshack.us)
My steering boss arrived in the post today so I could bolt it on to the snapp off boss I bought, jsut need to sork out what steering wheel Dish I want, seem to come out a fair old way, tried removing the std one, but wouldn't have any of it so I'm goignto go and borrow a mates steering wheel puller.
on
http://img390.imageshack.us/img390/7065/im000759a3gh.jpg (http://imageshack.us)
off
http://img390.imageshack.us/img390/7162/im000760a8fn.jpg (http://imageshack.us)
Also popped to the scrappy this morning, and bought the plastic chin spoiler from the std run of the mill corsa B's to add a bit of depth to the nouva bumper, used a 3mm bit in the drill and was able to carve the slit needed using that and got it all in, needed to trim 1/2" off each end to make it fit neatly.
http://img390.imageshack.us/img390/631/im000761a8ur.jpg (http://imageshack.us)
Here you can see th eblack tabs poking through at the back.
http://img390.imageshack.us/img390/3936/im000762a2kx.jpg (http://imageshack.us)
http://img373.imageshack.us/img373/958/im000755a1tb.jpg (http://imageshack.us)
My steering boss arrived in the post today so I could bolt it on to the snapp off boss I bought, jsut need to sork out what steering wheel Dish I want, seem to come out a fair old way, tried removing the std one, but wouldn't have any of it so I'm goignto go and borrow a mates steering wheel puller.
on
http://img390.imageshack.us/img390/7065/im000759a3gh.jpg (http://imageshack.us)
off
http://img390.imageshack.us/img390/7162/im000760a8fn.jpg (http://imageshack.us)
Also popped to the scrappy this morning, and bought the plastic chin spoiler from the std run of the mill corsa B's to add a bit of depth to the nouva bumper, used a 3mm bit in the drill and was able to carve the slit needed using that and got it all in, needed to trim 1/2" off each end to make it fit neatly.
http://img390.imageshack.us/img390/631/im000761a8ur.jpg (http://imageshack.us)
Here you can see th eblack tabs poking through at the back.
http://img390.imageshack.us/img390/3936/im000762a2kx.jpg (http://imageshack.us)