View Full Version : sri vernier pulley
novatracker
17-08-05, 11:34 PM
i just baught a vernier pulley 8) witch uses a square toothed belt . just got a sri and found the timing belt to have the round teeth on it.the timing belt ls longer due to it having a petentioner. is it posible to remove the petentioner and run a old style belt and crank pulley?
any help welcome
thanks
id deffo recomend binning the auto tensioner!
but as for changing to square tooth setup, you'd need to locate a square toothed waterpump otherwise the belt will get chewed in seconds!!!
the 1.2 (non spi) engine has the shorter belt to suit a non-tensionerd setup. and then take your std round tooth pulley to an engineering shop and ask for a kidney slot to be cut into where the peg goes..... shouldnt cost more than ?20
novatracker
18-08-05, 11:05 AM
sweet iv got my old sr at get every thing off put a new squire drive water pump and crank pully on it about 400 miles ago woth new belt ill have a look the day cheers.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.