PDA

View Full Version : T40 manifold on a Gte head!


General Baxter
05-08-05, 05:09 PM
erm... help what do i do here? :lol:

http://i11.photobucket.com/albums/a191/baxters83/carbs.jpg
mikey14sr
05-08-05, 06:06 PM
Get the right length inlet studs! they look about 2 inch too long
peester
05-08-05, 06:09 PM
use that blob of blue tac, near the pc..
-Bruce-
05-08-05, 07:05 PM
I would say tighten it up and hope for the best!! :roll:

Bruce
General Baxter
05-08-05, 11:01 PM
all done any 4 mole grips later :)

well i tried to just put the mole grips on the studs just went round,

then i welded a nut onto the thread, the stud snapped!

so then i welded 4 mole grips onto each stud and YAY!

:lol: :lol: :lol: :lol:

do weld in a garage with a box of polishing cloth in it ;)